the outside of the tube at both ends of the bail rod until the tube locks into the groove at each end of the bail rod.
Replace the cap and bail wire assembly by inserting each end of the bail wire into the bail rod, making certain they are fully
inserted before sliding the cap back into place on top of the tube.Assemble the port and silo assembly, if you chose to disassemble for easy and thorough cleaning, by placing the silo
assembly inside the port. Hold the silo assembly and port upside down and rotate the silo assembly until the three holes in
the port line up with the three plastic posts on the silo assembly. Replace the three screws.Install the tube by lining up the four holes in the tube with the four holes in the port and replace the tube screws. Do not
overtighten the screws as this will cause the tube to crack, especially in hot weather.Install the base by placing it up inside the port and aligning any of the three arrows on the underside of the base assembly
with the left hash mark on the side of the port, and turn clockwise (viewed from the bottom) until it clicks into place. The
arrow on the base assembly should be aligned with the right hash mark on the port when properly installed.
BASE (Motor Unit): Disassemble for Power Stick and Part ReplacementNote: Two changes were made to the Power Stick in 2008. The switch no longer has a vertical black pin which had a tendency to
indent or puncture the black switch bumper. This change will not affect the performance of the new Power Stick and will work in your
unit. The input jack on top of the Power Stick, for charging purposes, was also changed. Please contact Droll Yankees if your original
AC/DC Adapter (charger) will not fit into the input jack on top of your new Power Stick or if the black switch bumper on your base
assembly has become worn, indented or punctured. The black switch bumper can only be viewed for inspection by removing the
Power Stick from the base assembly. Please visit: http://drollyankees.com/video/yankee-flipper-power-stick-replacement/ Power Stick. Check the black activation switch, which is located on the base assembly, is in the "OFF" position.Use a 7/16" or 11mm socket, nut driver, or wrench to remove the nut at the bottom of the base, below the perch ring.